![]() In any case, you should try to adjust the steering levers per the instructions in the operator's manual. There should be access plates on top of the steering clutch housings to observe the brake bands and see if they are worn or soaked with oil, the two issues that can cause them to not grab and allow tight turns. The steering clutches allow for the sweeping turns sharp turns are initiated through actuation of the brake bands after disengagement of the steering clutches. If either or both of the tracks don't spin, then the steering clutches on that particular side are slipping. You can test to see if the steering clutches are slipping by pushing into a large pile of dirt or an ummoveable object like a tree or boulder and observe whether the tracks spin or not. You can have problems with the steering clutches and/or brake bands that lead to these issues. Is it time to replace clutches or does it sound like out of adjustment?Īre you saying both steering levers are inoperable in forward? but in reverse it will stop the track and turn the dozer. A few days ago I had a friend come over (Thank you Brian) and help me diagnose the electrical problem as a faulty wire to the starter. ![]() Gear type with mechanical dry disc clutchįorward: 10.5 kmh (6.5 mph) Reverse: 3.1 kmh (1.9 mph)įorward: 10.5 kmh (6.5 mph) Reverse: 10.5 kmh (6.Mrhurt wrote:I am looking at buying a 1962 jd 1010 crawler dozer.īut it seems to have problems, when going forward steering clutch is dead stick. Hey guys, just wanted to keep you updated on the progress for the John Deere 1010 dozer. John Deere 1010C Specifications General Specificationsġ20.7 N Front-mount John Deere 616: 93 in (2,360 mm) blade with hydraulic-lift and manual-angle.Front-mount John Deere 612: 80 in (2,030 mm) blade with hydraulic-lift and hydraulic-angle.Front-mount John Deere 610: 72 in (1,820 mm) blade with hydraulic-lift and manual-angle.gal) fuel tank.įollowing attachments are available for the John Deere 1010C industrial crawler: The JD 1010C is equipped with multiple disc clutch and brake steering, mechanical contracting band brakes, an open operator station, and 45.4 liters (12 US gal. This engine produced 40.5 PS (29.8 kW 40.0 HP) at 2,500 rpm of net output power and 128.8 N The cylinder bore is 92.0 mm (3.62 in) and the piston stroke is 89.0 mm (3.5 in). The John Deere 2010C is equipped with one of two engines: a 2.4 L (144.5 cu·in) four-cylinder gasoline / LP-gas engine or a 2.7 L (165.1 cu·in) four-cylinder diesel engine and a transmission with 8 forward and 4 reverse gears. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |